07002002: camera not detected
Creality Falcon · Creality Creality Falcon A1 Pro control firmware (8-digit fault codes by service group)
What it means
Camera not found by firmware
Can I keep running?
KB severity: warning
Sources in the knowledge base may allow limited running while the fault is investigated.
The knowledge base records this fault at technician fix level.
Where it points in the machine
camera (camera)
Source: Creality, fault code list
Models and controllers with this code
Source: Creality, fault code list
Related codes on this system
- 01001609 — home return failed, limit switch not found
- 01001039 — value out of range
- 01001041 — spindle not running in CSS/sync mode
- 01001043 — maximum feed rate exceeded
- 01001044 — RPM out of range
- 01001046 — zero the machine to proceed
- 01001048 — value conflict in G-code keyword
- 01001051 — motor failure
- 01003304 — alarm service interface timeout
- 01003305 — did not reach target position (log command)
- 01003306 — camera exposure control failed
- 01003307 — focus light spot not detected
Related symptoms in the knowledge base
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it