AL018: Abnormal signal output
Delta · Delta Delta ASDA-B2 AC servo drive
What it means
Drive tripped: abnormal signal output
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records this fault at technician fix level.
Where it points in the machine
servo_drive (drive)
Source: Unknown VN seller CDN, alarm table (publisher text only)
Source: Unknown VN seller CDN, alarm table (publisher text only)
Related codes on this system
- AL001 — Over current
- AL002 — Over voltage
- AL003 — Under voltage
- AL004 — Motor combination error
- AL005 — Regeneration error
- AL006 — Overload
- AL007 — Excessive speed deviation
- AL008 — Abnormal pulse command
- AL009 — Excessive deviation of position control
- AL011 — Encoder error
- AL012 — Adjustment error
- AL013 — Emergency stop
Related symptoms in the knowledge base
- Fibre source powered (green blink) but no laser output
- FTC signal wire alarm stops cutting
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
- Chiller panel reads normal but a red light is on and the buzzer sounds (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it