Err-L001: Laser failure!
Raytools · various (Raytools / Relfar / Au3tech / WSX welding and cleaning controllers) Handheld laser welding/cleaning controller error list (Err-xxxx, per raymark.ru reference)
What it means
Laser source fault reported
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records this fault at technician fix level.
Where it points in the machine
source
Source: Raymark (RU), code list (publisher text only)
Source: Raymark (RU), code list (publisher text only)
Related codes on this system
- Err-B001 — The air pressure is too low!
- Err-C001 — Chiller alarm!
- Err-E001 — The controller is not connected!
- Err-S001 — Wire feeder communication failure!
- Err-S002 — Stepping wire feeder driver alarm
- Err-S003 — Motor shaft lock failure!
- Err-W001 — Welding head communication failure!
- Err-W001 — Wireless communication failure!
Related symptoms in the knowledge base
- Laser module will not move
- F1 will not fire the laser
- Fibre source powered (green blink) but no laser output
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
This alarm involves mains power, high-voltage equipment, a laser source or an interlock. This is technician-only work. Do not attempt a repair yourself. Request a technician using the form on this page.
Get a tech on it