Nozzle bottom or side close the board surface
Weihong · Weihong Weihong NcStudio V15 laser tube cutting control system (LT3200)
What it means
Obstacle too high to cross while fast-follow response is on
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
height_sensing (height follow)
Source: Weihong (official OSS file store), 4.3 follow-up parameters
Source: Weihong (official OSS file store), 4.3 follow-up parameters
Related codes on this system
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it