Er002: Over-voltage protection
WSX · WSX WSX NC6 3E auto focus cutting head (pulse or bus drive)
What it means
Drive supply voltage too high
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
servo_drive (focus motor drive (pulse type))
Source: WSX (Shenzhen Worthing Technology), 11.1 pulse drive
Source: WSX (Shenzhen Worthing Technology), 11.1 pulse drive
Related codes on this system
- Er001 — Overcurrent protection
- Er020 — Out of position tolerance
- Er00d — Line disconnection protection
- ALM x1 — Overcurrent protection
- ALM x2 — Overvoltage protection
- ALM x3 — The instruction pulse increment is too large
- ALM x4 — Locking Axis Error
- ALM x6 — Self-tuning error
- ALM x7 — The location is very poor
- ALM x8 — Encoder Disconnection Detection
- ALM x10 — Emergency stop alarm
- ALM x11 — Positive and negative limit alarms
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it