AIRPUMP.ELEMENT_ABNORMAL.NTC_SHORT_CIRCUIT: Air pump current exception
xTool · xTool xTool P2S machine firmware/controller
What it means
Air assist pump fault: temperature sensor (NTC) short circuit.
Can I keep running?
KB severity: Degraded
The knowledge base lists this as a degraded fault. You may finish the current job if it is safe to do so, but plan a technician visit before normal production.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
air_assist (air pump / pump driver board)
Source: xTool (support.xtool.com), error code table
Models and controllers with this code
Source: xTool (support.xtool.com), error code table
Related codes on this system
- Water tank temperature too high
- Fan current too high
- SMOKING_FAN.CUR_LOW. — Fan current too low
- SMOKING_FAN.CUR_ABNORMAL.NOT_FOUND — Fan exceptions
- AIRPUMP.ELEMENT_ABNORMAL.CUR_HIGH — Air pump current exception
- AIRPUMP.ELEMENT_ABNORMAL.CUR_LOW — Air pump current exception
- AIRPUMP.ELEMENT_NOT_FOUND — Air pump current exception
- AIRPUMP.ELEMENT_ABNORMAL.TMEP_HIGH — Air pump current exception
- AIRPUMP.ELEMENT_ABNORMAL.STALLED — Air pump current exception
- AIRPUMP.ELEMENT_ABNORMAL.FIRST_PEAK_CUR_PROTECT — Air pump current exception
- AIRPUMP.ELEMENT_ABNORMAL.SECOND_PEAK_CUR_PROTECT — Air pump current exception
- AIRPUMP.ELEMENT_ABNORMAL.UPPER_MOS_ERR — Air pump current exception
Related symptoms in the knowledge base
- Smoke backing into the machine; room smell, dirty sensor (all models)
- Air Compress Assist not detected by S1 in XCS
- Chiller panel reads normal but a red light is on and the buzzer sounds (Thunder Laser AU troubleshooting list)
- Air assist pump does not run or no air when a job starts (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it