Leave board overtime
Friendess · Friendess BCS100
What it means
During calibration the controller did not see the nozzle lift clear of the sheet in time.
Can I keep running?
KB severity: setup
Sources in the knowledge base may allow limited running while the fault is investigated.
The knowledge base records this fault at technician fix level.
Where it points in the machine
calibration (capacitance calibration)
Source: Raysoar (machine maker), Ch2 s4.2 p12 (publisher text only)
Source: Raysoar (machine maker), Ch2 s4.2 p12 (publisher text only)
Related codes on this system
Related symptoms in the knowledge base
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
- Some areas of the same sheet do not cut through (uneven focus from bent material or table) (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it