error:17: Setting disabled
GRBL (gnea open-source project) · GRBL (gnea open-source project) GRBL firmware
What it means
Laser mode needs PWM output
Can I keep running?
KB severity: setup
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
job_setup (firmware)
Source: Diode Laser Wiki (community), error codes (publisher text only)
Source: GRBL project (gnea/grbl on GitHub, raw file), error_codes_en_US.csv row error:17
Source: Diode Laser Wiki (community), error codes (publisher text only)
Source: GRBL project (gnea/grbl on GitHub, raw file), error_codes_en_US.csv row error:17
Related codes on this system
Related symptoms in the knowledge base
- Laser module will not move
- F1 will not fire the laser
- Fibre source powered (green blink) but no laser output
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it