FTC signal wire alarm

unknown · unknown FTC height control (Gweike M-Series)

What it means

Fault in the height-control (FTC) signal chain between the cutting head and the controller.

Can I keep running?

KB severity: Machine down

The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.

The knowledge base records this fault at technician fix level.

Where it points in the machine

height_sensing (FTC height control signal cable / cutting head)

Source: The Yield Point (independent owner wiki), page title, meta description and inline troubleshooting route card (publisher text only)

Source: The Yield Point (independent owner wiki), meta description (publisher text only)

Source: The Yield Point (independent owner wiki), rendered body (thread unresolved at review date) (publisher text only)

Source: The Yield Point (independent owner wiki), page title, meta description and inline troubleshooting route card (publisher text only)

Source: The Yield Point (independent owner wiki), meta description (publisher text only)

Source: The Yield Point (independent owner wiki), rendered body (thread unresolved at review date) (publisher text only)

Related symptoms in the knowledge base

Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.

Get a tech on it

Tell us about the machine and the fault

We pass your details to independent technicians on the Kerfwise network. We aim to respond within 4 business hours (Monday to Friday, 8am to 5pm Brisbane time, excluding Queensland public holidays.).

Your details
The machine

Book maintenance

A response is a reply from a technician or from Kerfwise that acknowledges your job and the next step. It is not an on-site visit. We aim to respond within 4 business hours (Monday to Friday, 8am to 5pm Brisbane time, excluding Queensland public holidays.).