Flow alarm
unknown · unknown Handheld fibre laser welder/cleaner controller (maker not stated)
What it means
Controller is not getting a good water-flow signal from the chiller; causes include low water, a chiller fault, or flow monitoring enabled without wiring
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Likely causes
- low water
Source: Rayno Laser (CN machine maker blog), primary causes (publisher text only)
- a chiller fault
Source: Rayno Laser (CN machine maker blog), primary causes (publisher text only)
- flow monitoring enabled without wiring
Source: Rayno Laser (CN machine maker blog), primary causes (publisher text only)
Related symptoms in the knowledge base
- FTC signal wire alarm stops cutting
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
- Chiller panel reads normal but a red light is on and the buzzer sounds (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it