RED_LASER_HEAD.TMP_HIGH: Infrared laser module temperature too high
xTool · xTool xTool P3 machine firmware/controller
What it means
Infrared laser module is too hot.
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
thermal (IR laser module)
Source: xTool (support.xtool.com), error code tables
Models and controllers with this code
Source: xTool (support.xtool.com), error code tables
Related codes on this system
- BOARDS.ELEMENT_NOT_FOUND.motion_gd470 — Main control board is disconnected
- BOARDS.ELEMENT_NOT_FOUND.airpump_gd303 — Main control board is disconnected
- BOARDS.ELEMENT_NOT_FOUND.z_axis_gd303 — Main control board is disconnected
- BOARDS.ELEMENT_NOT_FOUND.display_gd757 — Main control board is disconnected
- CONTROLLER.TMP_HIGH.MASTER — Main controller temperature is too high
- GO_HOME.FAILED.X_AXIS — Gantry homing exception
- GO_HOME.FAILED.Y_AXIS — Gantry homing exception
- GO_HOME.FAILED.Z_AXIS — Gantry homing exception
- GO_HOME.FAILED.V_AXIS — Gantry homing exception
- MOTOR_DRIVER.ELEMENT_ABNORMAL.X_AXIS — Motor driver exception
- MOTOR_DRIVER.ELEMENT_ABNORMAL.Y_AXIS_L — Motor driver exception
- MOTOR_DRIVER.ELEMENT_ABNORMAL.Y_AXIS_R — Motor driver exception
Related symptoms in the knowledge base
- Laser module will not move
- F1 will not fire the laser
- Fibre source powered (green blink) but no laser output
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it