Step 3: Gweike GKS-6008TA
- 1 Make
- 2 Model
- 3 Next step
Gweike GKS-6008TA is supported by our technician network.
We have 60 published code notes for Gweike in the knowledge base.
Or use Ask Kerfwise on the homepage.
Codes linked to this model (60)
- Leveling failure, X, Z, B axis might reverse
- Setup error of travel range, edge seeking failure
- Incorrect height parameters
- Edge seeking failure
- Holder delay alarm
- Holder exceeds the position
- Holder alarm
- Chuck
- Excessive following error
- The follower is too close to the board
- Z axis -limit enabled
- Z axis +limit enable
- Z axis soft -limit enable
- Z axis soft +limit enable
- The capacitance is zero
- Abnormal increase of capacitance
- Capacitance decrease
- Capacitance increase
- Z axis servo alarm
- The control card is loose or pulled out
- Axis N positive / negative limit enable
- Axis N positive / negative soft limited position enable
- Axis N servo alarm
- Emergency stop
- Axis N returns ORG abnormally, motion axis remains working
- Failed to capture the switch signal when axis N returns ORG
- Switch signal keeps enable when axis returns ORG
- The position deviation of axis N double drive is too large
- User-defined alarm
- Illegal parameter configuration