Incorrect height parameters
Gweike · Friendess TubePro
What it means
Entered tube size does not match the real tube, or axis scaling is off.
Can I keep running?
KB severity: setup
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
motion_setup (tube parameters)
Source: Conintel (cypcut.ru, RU distributor), s3.2 Abnormal alarm list p59-63 (p59) (publisher text only)
Models and controllers with this code
Source: Conintel (cypcut.ru, RU distributor), s3.2 Abnormal alarm list p59-63 (p59) (publisher text only)
Related codes on this system
- Leveling failure, X, Z, B axis might reverse
- Setup error of travel range, edge seeking failure
- Edge seeking failure
- Holder delay alarm
- Holder exceeds the position
- Holder alarm
- Chuck
- Excessive following error
- The follower is too close to the board
- Z axis -limit enabled
- Z axis +limit enable
- Z axis soft -limit enable
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it