Edge seeking failure
Gweike · Friendess TubePro
What it means
The tube edge search did not complete.
Can I keep running?
KB severity: setup
Sources in the knowledge base may allow limited running while the fault is investigated.
The knowledge base records this fault at technician fix level.
Where it points in the machine
motion_setup (X/Z/B axis config / Z calibration)
Source: Conintel (cypcut.ru, RU distributor), s3.2 Abnormal alarm list p59-63 (p60) (publisher text only)
Models and controllers with this code
Source: Conintel (cypcut.ru, RU distributor), s3.2 Abnormal alarm list p59-63 (p60) (publisher text only)
Related codes on this system
- Leveling failure, X, Z, B axis might reverse
- Setup error of travel range, edge seeking failure
- Incorrect height parameters
- Holder delay alarm
- Holder exceeds the position
- Holder alarm
- Chuck
- Excessive following error
- The follower is too close to the board
- Z axis -limit enabled
- Z axis +limit enable
- Z axis soft -limit enable
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it