Communication with controller failed
xTool · LightBurn Software LightBurn
What it means
LightBurn on macOS cannot talk to a P2S over USB although xTool Studio can
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
Where it points in the machine
software (USB/serial link)
Source: LightBurn Software Forum, opening post (publisher text only)
Models and controllers with this code
Source: LightBurn Software Forum, opening post (publisher text only)
Related codes on this system
Related symptoms in the knowledge base
- XCS cannot find the machine over USB
- Software stops working with the machine after a firmware upgrade (XCS or Studio below 1.6)
- S1 depth probe misbehaves in xTool Studio (software bug per video)
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it