M363 S4: Distance measurement exceptions.
xTool · xTool xTool S1 machine firmware/controller
What it means
Auto distance measurement fault (variant S4).
Can I keep running?
KB severity: Degraded
The knowledge base lists this as a degraded fault. You may finish the current job if it is safe to do so, but plan a technician visit before normal production.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
focus (distance sensor)
Source: xTool (support.xtool.com), M363 table
Source: xTool, lookup sheet
Source: xTool, issue description
Models and controllers with this code
Source: xTool (support.xtool.com), M363 table
Source: xTool, lookup sheet
Source: xTool, issue description
Related codes on this system
- M222 S4 — Device moved
- M222 S7 — Start processing without a project file or with the lid opened
- M222 S9 — Flame detected
- M222 S20 — The device reached position limits during processing
- M222 S21 — Communication exceptions between the Wi-Fi module and the main controller
- M222 S22 — Communication exceptions between the laser module and the main controller
- M363 S0 — Distance measurement exceptions.
- M363 S2 — Distance sensor signal exceptions.
- M363 S3 — The distance sensor has not been reset.
- M363 S5 — Distance measurement exceptions.
- M53 T0 — SD card exceptions or failure
- M53 T0 — The flash storage encounters an exception or is damaged
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it