Friendess TubePro
- Leveling failure, X, Z, B axis might reverse
- Setup error of travel range, edge seeking failure
- Incorrect height parameters
- Edge seeking failure
- Holder delay alarm
- Holder exceeds the position
- Holder alarm
- Chuck
- Excessive following error
- The follower is too close to the board
- Z axis -limit enabled
- Z axis +limit enable
- Z axis soft -limit enable
- Z axis soft +limit enable
- The capacitance is zero
- Abnormal increase of capacitance
- Capacitance decrease
- Capacitance increase
- Z axis servo alarm
- The control card is loose or pulled out
- Axis N positive / negative limit enable
- Axis N positive / negative soft limited position enable
- Axis N servo alarm
- Emergency stop
- Axis N returns ORG abnormally, motion axis remains working
- Failed to capture the switch signal when axis N returns ORG
- Switch signal keeps enable when axis returns ORG
- The position deviation of axis N double drive is too large
- User-defined alarm
- Illegal parameter configuration
- Bus network alarm (please remove the alarm manually)
- Bus network alarm <network line XX is broken>
- Bus network alarm (RTOS startup problem, system startup failed)
- Bus network alarm (RTOS startup problem, not prepared)
- Bus network alarm (RTOS startup problem, RTOS bin file version is incorrect)
- 0x9811000C — 0x9811000C — Bus network alarm (network card opening failed 0x9811000C)
- 0x9811001A — 0x9811001A — Bus network alarm (license error 0x9811001A)
- Bus network alarm (network mismatch)
- Bus network alarm (configuration file read failure)
- 0x98110021 — 0x98110021 — Bus network alarm (cycle instruction loss 0x98110021)
- Bus network alarm (station error)
- 0x98110025 — 0x98110025 — Bus network alarm (frame loss 0x98110025)
- 0x98110026 — 0x98110026 — Bus network alarm (instruction frame loss 0x98110026)
- 0x98110027 — 0x98110027 — Bus network alarm (station loss 0x98110027)
- Bus network alarm (station is not in the Op mode)
- 0x9811002B — 0x9811002B — Bus network alarm (station loss 0x9811002B)
- Bus network alarm (network wire unconnected)
- 0x98110039 — 0x98110039 — Bus network alarm (license error 0x98110039)
- Bus network alarm (no configuration file is found)
- Bus network alarm (change of network link topology)
- Bus network alarm (network line cross information error)
- Bus network alarm (hardware error)
- Bus network alarm (hardware CPU error)
- Bus network alarm (DC cycle is incorrect)