Step 3: Gweike LF3015GAR
- 1 Make
- 2 Model
- 3 Next step
Gweike LF3015GAR is supported by our technician network.
Systems and controllers we have notes for
Or use Ask Kerfwise on the homepage.
Codes linked to this model (57)
- Leveling failure, X, Z, B axis might reverse
- Setup error of travel range, edge seeking failure
- Incorrect height parameters
- Edge seeking failure
- Holder delay alarm
- Holder exceeds the position
- Holder alarm
- Chuck
- Excessive following error
- The follower is too close to the board
- Z axis -limit enabled
- Z axis +limit enable
- Z axis soft -limit enable
- Z axis soft +limit enable
- The capacitance is zero
- Abnormal increase of capacitance
- Capacitance decrease
- Capacitance increase
- Z axis servo alarm
- The control card is loose or pulled out
- Axis N positive / negative limit enable
- Axis N positive / negative soft limited position enable
- Axis N servo alarm
- Emergency stop
- Axis N returns ORG abnormally, motion axis remains working
- Failed to capture the switch signal when axis N returns ORG
- Switch signal keeps enable when axis returns ORG
- The position deviation of axis N double drive is too large
- User-defined alarm
- Illegal parameter configuration